85mm PG-7V Rocket
3D Prints > RPG > 85mm PG-7V Rocket
The 85mm PG-7V Rocket is a 10.74 hour print with an estimated cost to print of €7.73 + parts and labor.
- Connect
nosecone.stltonosecone_base.stl - Connect
nozzle.stltonosecone_base.stl - Connect
fuze.stltonosecone.stl - Insert
motor_a.stlintomotor_b.stlalign the grooves to the tabs and press the two ends together until they snap and lock in place - Connect
motor_nozzle.stltomotor_a.stlto create the motor assembly - Install M5x10x7 brass heat-set insert into
motor_b.stl, screw M3x8mm hex screw and washer intomotor_a.stl - Connect the motor assembly to the warhead
- Connect 4x
fin.stltotailfin.stlusing the 10mm self-tapping screws - Connect
prop.stltotailfin.stlto create the tailfin assembly - Connect the tailfin assembly to the rocket assembly to create the 85mm-pg-7v-rocket
Copy object namekey for print order:
STL Files
Build Plates
plate_1.png
plate_2.png
plate_3.png
Parts
| Quantity | Part | Notes |
|---|---|---|
| 4 | m3-10-countersunk-screw | |
| 1 | m3-8-hex-screw | For motor_a.stl |
| 1 | m3-washer | For motor_a.stl |
| 1 | m5-10-7-brass-heat-set-insert | For motor_b.stl |