TM-62M Landmine
3D Prints > Landmine > TM-62M Landmine
The TM-62M Landmine is a 18.87 hour print with an estimated cost to print of €14.38 + parts and labor.
- Connect
fuze-well.stltomine-body.stl - Connect
mine-base.stltomine-body.stl - With model facing down, add thin layer of glue and install
strap-mount-1.stlandstrap-mount-2.stlontomine-base.stl - Add thin layer of glue along outer edge of round ridge and square tabs on
mine-base.stland connect 1xplug-mount.stlover each opening (with flat edge facing toward center of mine), allow time to dry - Add thin layer of glue and connect 1x
plug-insert.stltoplug.stl, when dry insert plugs into each opening ofmine-base.stland turn to lock in place
Known issues
-
Mine-body interior and fuze-well slightly deviate from actual design
-
Glue needed for filler plug parts
-
Lightly sand the outer edges of
plug-insert.stlto reduce friction when inserted -
Strap mounts are not load bearing, can break. Can be reprinted and re-attached
Copy object namekey for print order: